duplicating mould
of the duplicating silicone with Neutrasil
(REF 101603).
adhesive tape round the mould
ensure that the surface of the investment model
is free from blows.
to Hydrosil duplicating moulds, because
this special silicone has unique hydrophilic
properties and produces perfect models
without applying wetting agent.
the duplicate model
according to the instructions (Granisit®,
Micro, Jet 2000). Follow the instructions
and advice on storage and working
temperatures.
Recommended working temperature
17°C - 19°C
Recommended storage temperature
8°C - 12°C
investment
onto the vibrator and pour the contours using
high vibration. It may be helpful to use an
instrument when pouring. If required, place the
mould under pressure (2.5 - 6.0 bar),
following precisely the instructions for using
the different investments.
immediately after filling.
Do not vibrate again.
depending on the type of investment used.
During expansion, temperatures can
reach 85°C.
duplicate model
from the duplicating mould approx.
30 min. after pouring.
Caution: SILADENT investment
models should not be dried in a
hot air cabinet or dipped in hardener.
wax adhesive
(REF 102501) 1 – 2 times thinly
on areas where preformed wax
patterns are to be placed.
attaching sprues
sprues in the SILADENT-System.
the investment model
trimmed (dry) before the crepe
sleeve is placed around it.
Ensure that there is a uniform gap
for investment of at least 5 mm
between the model and sleeve.
release and vent sprues.
and vent 1.2 mm Ø
sprues 2.0 – 2.5 mm Ø
model 15 mm
at the sides at least 5 mm
3-4 mm above the highest
point of pattern
point of the pattern
ring tape
tape (REF 102601) around the model
prepared for investing.
Wetting agent is not required.
according to the instructions and
pour using minimum vibration.
Important! Switch off the vibrator
immediately after the wax pattern
is covered. Do not vibrate again.
conventional preheating
depends on the investment used. With
speed investments, follow the instructions
precisely regarding the time for placing
the casting ring in the hot furnace.
Conventionally preheated investments
are placed in a cold furnace, with the
sprue former facing down, at least 60 min.
after investing and then preheated according
to the preheating parameters in the instructions.
Technical Support
for technical questions:
+49 53 21 - 37 79 239
+49 53 21 - 37 79 239
